Archive for 'CCNA Study Labs' Category
CCNA640-802 ACL design problem
ACL configuration
(1) Standard ACL
Step 1 Configured on the router host name and password
Step 2 Configure the Ethernet segment of the PC
a. PC 1
IP address 192.168.14.2
Subnet mask 255.255.255.0
Default gate...
CCNA640-802 Frame relay design problem
Frame relay
FR in the real exam HOSTNAME read: MidEast, can show run or show frame-relay map to view.
The MidEast network topology and the output of MidEast 1 are shown below:
Please study the exhibit shown above carefully, and answ...
CCNA640-802 NAT network design problem
NAT
Experiment of NAT in overload Do not miss save the configuration copy run start.
NAT does not need two interfaces with inside and outside, that can be done to take the left side of the small computer Ping Tung ISP, and then click to sa...
CCNA640-802 RIPv2 network design problem
RIPv2
RIPv2 was first described in RFC 1388 and RFC 1723 (1994); the current RFC is 2453, written in November 1998. Although current environments use advanced routing protocols such as OSPF and EIGRP, there still are networks using RIP . The nee...
New CCNA certification test LAB questions of 16-22
Lab.16 Drag each feature on the left to the appropriate routing protocol on the right.
Lab.17 Drag the connection types on the left to the appropriate type of cable used on the right. (Not all options are used.)
Lab.18 Drag the descripti...
New CCNA certification test LAB questions of 11-15
11.Lab Drag the appropriate 5 steps of the boot sequence on the left to their correct slots on the right. (Not all options apply.)
12.Lab Drag the Cisco default administrative distance to the appropriate routing protocol or route. (Not all opti...
New CCNA certification test LAB questions of 6-10
6.Lab
Question #1
Answer: E
Question #2
Answer: B
Question #3
Answer: A
7.Lab
Refer to the exhibit. PC_1 is sending packets to the FTP server. Consider the packets as they leave RouterA interface Fa0...
New CCNA certification test LAB questions
1.Lab
Answer:
Bomar(Config)#interface fa0/0
Bomar(Config-if)#ip nai inside
Bomar(Config)#interface S0/0
Bomar(Config-if)#ip nat outside
Bomar(Config-if)#exit
Bomar(Config)#access-list 1 permit 192.168.16.33 0...
Float Static Routing
Step 1: Configure IP address for each router and use the ping command to identify whether the directly connected interfaces can ping each other.
Step 2: Configure the static route on R1 to the loopback interface on R2
R1(config)#ip route ...
CCNA Access List Sim
(Updated from real CCNA exam on 07-March-2009)
Question:
An administrator is trying to ping and telnet from Switch to Router with the results shown below:
Switch>
Switch> ping 10.4.4.3
Type escape sequence to abor...