CCNA 640-802 certification!

Archive for 'Switching' Category

Example Analysis

【Lab Objectives】 You have just been hired by pass4sure.com to help their main office expand. The main offices have enhanced their wiring closets with some Layer 3 switches. The new distribution layer switch has been installed and a new ac...

Configuring PVLAN

【Lab Objectives】 Keep the following restrictions in mind when configuring PVLANs correctly: • PVLAN trunk ports support only IEEE 802.1q encapsulation. • Community VLANs are not supported in this release. • You cannot ch...

Configuration of VACL

【Lab Objective】 1. Familiar and complete the configuration of vlan access control list to control communications in Vlan.
【Lab Topology】
Lab topology instructions: Use tow routers to simulate hosts and put them i...

Configuring L2 & L3 EtherChannel with PAgP

【Lab Objectives】 1. Master the configuration methods of the Cisco-proprietary link aggregation protocol of PAgP. 2. Master the differences between the Layer2 PAgP configuration and the Layer3 PAgP configuration. 3. PAgP is a Cisco-proprie...

Routing Between VLANs and VTP Protocol

【Lab Objectives】 1. Master the VTP configuration methods. 2. Master the routing configuration methods between VLANs and the sub-interface configurations.
【Lab Topology】 【Lab steps and requirements】 1. Confi...

Configuring 802.1x Port-Based Authentication

【Lab Objectives】 1. Master the 802.1x Port-Based configuration methods. 2. Master Cisco TACACS+Authentication Server configuration
【Lab Topology】 【Lab Steps and Requirements】 1. We recommend you to use j2r...

CCENT: Providing Basic Password Security for a Cisco Router or Switch

One of the many skills that you must demonstrate as a CCENT candidate is your ability to configure basic password security on a Cisco router or switch. This blog post walks you through the configurations you must have mastered in order to succeed in t...