Archive for 'CCNP' Category
642-892 part 4
121.What is the objective of setting the VTP mode to transparent ? A.Transparent mode will only forward messages and advertisements, not add them to their own database. B.Transparent mode makes a switch dynamically secure. C.Transparent mode will forw...
642-892 part 3
61.When the passive-interface command is used on a router, which two routing protocols will go on to receive routing updates on an interface configured as passive? (Choose two.) A.EIGRP B.RIP C.RIPv2 D.OSPF Correct:B C 62.In the hardware address 0000....
642-892 part 2
31.Which three descriptions are correct concerning the diagram below? (Choose three.) A.A trunk link will be formed. B.Only VLANs 1-1001 will travel across the trunk link. C.The native VLAN for -B is vlan 1. D.DTP packets are sent from -B. Correct:A C...
642-892 part 1
1.6to4 tunneling uses a simple mechanism to create automatic tunnels. Which two statements accurately describe 6to4 tunneling? (Choose two.) A.2002::/48 is the address range specifically assigned to 6to4. B.Each 6to4 site receives a /48 prefix in a 6t...
CCNP BSCI –Chapter 21 IPv6 Routing Protocols, Configuration, and Transitioning from IPv4
1. Which of the following routing protocols support IPv6?
A. RIPv2
B. EIGRP
C. OSPFv3
D. ODR
2. How is a default route represented in IPv6?
A. 0/0
B. 0:0:0:0:0:0:0:0/0
C. ::/0
D. 0::0/0
3. Wh...
CCNP BSCI –Chapter 20 Introduction to IPv6 and IPv6 Addressing
1. How long is an IPv6 address?
A. 16 hexadecimal numbers
B. 32 decimal numbers
C. 128 bits
D. 32 bits
2. For which field in the IPv4 header is there not a similar field in the IPv6 header?
A. Version
B. ToS
CCNP BSCI –Chapter 19 Configuring Multicast
1. What common engineering problem must be solved by all multicast implementations?
A. Identifying multicast servers
B. Preventing multicast storms
C. Preventing multicast loops
D. Multicast TTL
2. Which of the following ...
CCNP BSCI –Chapter 18 IGMP
1. Layer 2 switches build a MAC table by observing which of the following?
A. Source address and port
B. Destination address and port
C. Source VLAN
D. Broadcast address and VLAN
2. IGMP stands for which of the following?...
CCNP BSCI –Chapter 17 What Is Multicasting?
1. Which of the following describes a difference between broadcasts and multicasts?
A. Multicasts are one-to-many
B. Multicasts are unidirectional
C. Multicasts are routable
D. Multicasts are used by RIPv1
2. Multicasting...
CCNP BSCI –Chapter 16 Controlling BGP Route Selection
1. Well-known mandatory attributes are described as which of the following?
A. Must be included in updates
B. Must be supported
C. Stripped if not recognized
D. Marked partial if not recognized
2. Optional nontransitive a...