Archive for 'BGP' Category

BGP is ignored in the security!

By admin - Last updated: Thursday, November 19, 2009

BGP is ignored in the security!

Routing Switch command set of these articles, on-line already are not many, but the design to security, but also a few little.
Border Gateway Protocol BGP is aVarious companies, enterprises and other local ...

Configuring BGP Weight

By admin - Last updated: Tuesday, May 19, 2009

Lab Objectives: 1. When the local export router has a number of outward self-government system link, it needs to apply the weight attributes which can decide the data flow to outflow of the local self-government system from which exit link of the loca...

Configuring BGP Multi-Exit Discriminator

By admin - Last updated: Tuesday, May 19, 2009

Lab Objectives: 1. To understand how the BGP attributes to impact the data flow of other self-government system to flow into the local self-government system. 2. To master the MED configuration methods on base of route-map.
Lab Topology Exhibit:...

Configuring BGP Local Preference

By admin - Last updated: Tuesday, May 19, 2009

Lab Objectives: 1. To master the concept of local properties and configuration optimization methods of BGP. 2. Local selection of properties for the default value is 100; the higher value of the path will be the preferred option. 3. Local priority pro...

BGP Neighbor Authentication

By admin - Last updated: Tuesday, May 19, 2009

Lab Objectives: 1. To master the authentication configuration of peer of BGP for MD5.
Lab Topology: Lab Process and Requirements: 1. Configure the router’s IP address, and use the command Ping to confirm the connect’s interoperabilit...

Configuring BGP Summarization

By admin - Last updated: Tuesday, May 19, 2009

Lab Objectives: 1. To master the summary configuration methods which points to the static routing of interface NULL0. 2. To master the summary configuration methods by using aggregation-property route.
Lab Topology:
Lab Process and Requir...

Configuring BGP Using Loopback Addresses

By admin - Last updated: Tuesday, May 19, 2009

Lab Objectives: 1. To master the configuration methods which established on the basis of loopback of BGP neighbor relationship. 2. To understand the objective of using loopback.
Lab Topology:
Lab Process and Requirements: 1. Configure the...

Configuring Basic BGP

By admin - Last updated: Monday, May 18, 2009

Lab Objectives: 1. To master the basic configuration methods of BGP. 2. To master how to view the variety of BGP configuration information.
Lab Topology:
Lab Process and Requirements: 1. Configure the router’s IP address, and use the...

BGP Case Studies

By admin - Last updated: Monday, April 27, 2009

Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information presented in this document was c...

Using Extended ACLs for BGP Filtering

By admin - Last updated: Sunday, February 1, 2009

Prior to the support of prefix-lists in the IOS advanced filtering for BGP needed to be done using extended ACLs.? The syntax for using extended ACLs is shown below:
access-list <ACL #> permit ip <network> <wildcard mask of networ...