CCNA 640-802 certification!

Archive for 'CCNP Study Labs' Category

4 Experiment of 642-892

196．LAB

The information of the question You will configure FastEthernet ports 0/12 through 0/24 for users who belong to VLAN 20. Also, all VLAN and VTP configurations are to be completed in global configuration mode as VLAN database mode i...

Example Analysis

【Lab Objectives】 You have just been hired by pass4sure.com to help their main office expand. The main offices have enhanced their wiring closets with some Layer 3 switches. The new distribution layer switch has been installed and a new ac...

Configuring PVLAN

【Lab Objectives】 Keep the following restrictions in mind when configuring PVLANs correctly: • PVLAN trunk ports support only IEEE 802.1q encapsulation. • Community VLANs are not supported in this release. • You cannot ch...

Configuration of VACL

【Lab Objective】 1. Familiar and complete the configuration of vlan access control list to control communications in Vlan.
【Lab Topology】
Lab topology instructions: Use tow routers to simulate hosts and put them i...

Configuring L2 & L3 EtherChannel with PAgP

【Lab Objectives】 1. Master the configuration methods of the Cisco-proprietary link aggregation protocol of PAgP. 2. Master the differences between the Layer2 PAgP configuration and the Layer3 PAgP configuration. 3. PAgP is a Cisco-proprie...

Routing Between VLANs and VTP Protocol

【Lab Objectives】 1. Master the VTP configuration methods. 2. Master the routing configuration methods between VLANs and the sub-interface configurations.
【Lab Topology】 【Lab steps and requirements】 1. Confi...

Configuring 802.1x Port-Based Authentication

【Lab Objectives】 1. Master the 802.1x Port-Based configuration methods. 2. Master Cisco TACACS+Authentication Server configuration
【Lab Topology】 【Lab Steps and Requirements】 1. We recommend you to use j2r...

Configuring BGP Weight

Lab Objectives: 1. When the local export router has a number of outward self-government system link, it needs to apply the weight attributes which can decide the data flow to outflow of the local self-government system from which exit link of the loca...

Configuring BGP Multi-Exit Discriminator

Lab Objectives: 1. To understand how the BGP attributes to impact the data flow of other self-government system to flow into the local self-government system. 2. To master the MED configuration methods on base of route-map.
Lab Topology Exhibit:...

Configuring BGP Local Preference

Lab Objectives: 1. To master the concept of local properties and configuration optimization methods of BGP. 2. Local selection of properties for the default value is 100; the higher value of the path will be the preferred option. 3. Local priority pro...