Archives by Tag 'routing'
free download Cisco 350-001
1. Into which two types of areas would an area border router (ABR) inject a default route?(Choose two.)Select 2 response(s). A. the autonomous system of a different interior gateway protocol (IGP) B. area 0 C. totally stubby D. NSSA E. stub F. the aut...
CCNP BSCI –Chapter 21 IPv6 Routing Protocols, Configuration, and Transitioning from IPv4
1. Which of the following routing protocols support IPv6?
A. RIPv2
B. EIGRP
C. OSPFv3
D. ODR
2. How is a default route represented in IPv6?
A. 0/0
B. 0:0:0:0:0:0:0:0/0
C. ::/0
D. 0::0/0
3. Wh...
CCNP BSCI –Chapter 11 Implementing Redistribution and Controlling Routing Updates
1. Which of the following are reasons to run multiple routing protocols?
A. Applications requiring UNIX
B. Smaller routing domains speed up convergence
C. Transitioning from one routing protocol to another
D. Smaller routing do...
Layer 3 Routing
Devices involved in Layer 3 routing perform the following functions: ■ Packets are forwarded between networks based on Layer 3 addresses. ■ An optimal path is determined for a packet to take through a network to the next router. ■ Packet forward...
CCIE ® Routing and Switching Written Exam Topics
CCIE ® Routing and Switching Written Exam Topics
Exam Sections and Sub-task Objectives
1.00
Implement Layer 2 Technologies
√
1.10
Implement Spanning Tree Protocol (STP)
(a) 802.1d
(b) 802....
Float Static Routing
Step 1: Configure IP address for each router and use the ping command to identify whether the directly connected interfaces can ping each other.
Step 2: Configure the static route on R1 to the loopback interface on R2
R1(config)#ip route ...
The study of the command eigrp stub and the parameters
Experimental objective: Validate the functions of the command eigrp stub in hub-spoke link, as well as the differences after adding different parameters.
Initial configuration:
R1
interface Ethernet0/0
ip address 10.1.1.1 255.2...
Routing Between VLANs and VTP Protocol
ã€Lab Objectives】 1. Master the VTP configuration methods. 2. Master the routing configuration methods between VLANs and the sub-interface configurations.
ã€Lab Topology】 ã€Lab steps and requirements】 1. Confi...
Configuring Basic BGP
Lab Objectives: 1. To master the basic configuration methods of BGP. 2. To master how to view the variety of BGP configuration information.
Lab Topology:
Lab Process and Requirements: 1. Configure the router’s IP address, and use the...
Configuring OSPF NSSA Area and NSSA Totally Stub
Lab objectives: 1. Learn functions of type1, type2, type3, type4, type5, and type7 LSA in Totally Stub Area. 2. Learn features of NSSA Area and NSSA Totally Stub Area 3. Learn the two area configuration methods Note: Totally NSSA is CISCO private.